FORMLABS GREY RESIN

Basic information

Chemical formula(s): Contains Urethane Dimethacrylate (55-75%), Methacrylate Monomers (15-25%)
Other names: Grey Resin, SLA Printer Resin
Product Code: FLGPGR04
International Chemical Safety Card (ICSC): Multiple components - see individual ICSC cards
Flammability: Not flammable (flash point >93.5°C)
Description: Photopolymer resin for use in Formlabs SLA 3D printers. Contains urethane dimethacrylate and methacrylate monomers.

Health (blue): 2 - intense or continued but not chronic exposure could cause temporary incapacitation or possible residual injury.
Flammability (red): 1 - must be pre-heated before ignition can occur (flash point >93.5°C).
Instability–reactivity (yellow): 1 - normally stable, but can become unstable at elevated temperatures and pressures.
Special notice (white): - - no special hazards.

Code	Phrase
H317	may cause an allergic skin reaction
H319	causes serious eye irritation
H411	toxic to aquatic life with long lasting effects

Code	Phrase
P261	avoid breathing dust/fume/gas/mist/vapours/spray
P264	wash skin thoroughly after handling
P272	contaminated work clothing should not be allowed out of the workplace
P273	avoid release to the environment
P280	wear protective gloves, protective clothing and eye protection
P302+P352	IF ON SKIN: wash with plenty of soap and water
P305+P351+P338	IF IN EYES: rinse cautiously with water for several minutes, remove contact lenses if present and easy to do, continue rinsing
P333+P313	if skin irritation or rash occurs: get medical advice/attention
P337+P313	if eye irritation persists: get medical advice/attention
P363	wash contaminated clothing before reuse
P391	collect spillage
P501	dispose of contents and container in accordance with local, regional, national, and international regulations

Based on the safety data sheet recommendations for handling photopolymer resins:

Nitrile: very good - chemical resistant, impervious gloves recommended for handling acrylate resins.
Butyl rubber: good - chemical resistant gloves suitable for extended contact.
Natural latex or rubber: poor (not recommended) - not suitable for handling methacrylate compounds.
Viton™: very good - excellent chemical resistance.

Always wear safety glasses or goggles when handling this product.
Use eye protection equipment that has been tested and approved by recognized national standards.
Corrective glasses are not considered safety goggles.

Use with adequate ventilation.
If engineering controls do not maintain airborne concentrations below applicable limits, wear approved respirator.
Emergency eye wash stations and safety showers should be available.

Evacuate unnecessary personnel and ventilate area.
Extinguish any sources of ignition.
Wear recommended personal protective equipment.
Stop leak if safe to do so.
Prevent from reaching drains, sewers and waterways.
Contain and collect spillage and place in suitable container for disposal.
Avoid contact with skin, eyes and clothing.
Do not touch damaged containers or spilled material unless wearing appropriate protective clothing.
Dispose according to local hazardous waste regulations.

May cause allergic skin reaction - skin sensitization can occur, discontinue use if sensitization develops.
Causes serious eye irritation - avoid contact with eyes.
Toxic to aquatic life with long lasting effects - prevent release to environment.
Avoid exposure to light and heat - store below 38°C (100°F) away from direct sunlight.
Incompatible with peroxides, strong oxidizing agents, alcohols, copper, and strong bases.
Keep containers tightly closed when not in use.
Use only in well-ventilated areas.